Vestax PMC 250 Manual de usuario

Professional Mixing ControllerVESTAX CORPORATION1-18-6 Wakabayashi, Setagaya-ku, Tokyo 154-0023 JapanPhone:03-3412-7011 Fax:03-3412-7013Web:www.vestax

9HOW TO CHANGE THE JACK PANEL POSITIONThe I/O jack panel of the PMC-250 can be placed either on the top or back side of the unit. Pleaserefer to foll

10BLOCK DIAGRAMLRRIAAATTATTRIAALINE 1LINE 3PH ONO 1PH ONO 2PH ONO 3LINE 2LINE 4LINE 5MICMASTER LEVELBO OTH LEVELINPUTSELECTORINPUTSELECTORTRIMTRIMMIC

Vestax CorporationSPECIFICATIONSINPUTSECTION MIC（1/4' PHONE JACK） -50dBv -20dBv 3.3kΩ PHONO 1∼3L/R （RCA PIN JACK） -42dBv -22dB v 2

1CONGRATULATIONS！The lightning flash with arrowhead symbol，within an equilateral triangle，is intended toalert the user to the presence of uninsulated“

21. Read instructions-All the safety and operatinginstructions should be read before the applianceis operated.2. Retain instructions-The safety and op

315. Damage Requiring Service-Unplug this productfrom the wall outlet and refer servicing toqualified service personnel under the followingconditions:

4FUNCTIONSPROGRAM SECTION21MAXMINMAXMINMAXMINMAXMINMAXMINMAXMINPRO FESSIONAL MIXING CONTROLLERLEVELINPUT FILTERLOW MID HIMICINCUTISOLATORISOLATOR ISOL

u HI CUT (Fader type cut switch HI)When this volume is set to bottom position, highfrequency range is cut of completely regardlessof the position of t

6MONITOR SECTIONMAXMINCUE SELECTORSTEREO CUELEVELPHONESONOFF12AUXMONITOR21222324@1 CUE SELECTORUsed to select the cue signal to be monitored byheadpho

7CONNECTION EXAMPLEPLAY/PAUSECUEPLAY/PAUSECUEKEYPITCHREVERSEOPEN/CLOSESTOPDISPLAYREPEATABSEARCHTRACKMIN SEC FRM ENTER 123LOOPSTARTENDRELOOP/EXITPOINT

8HOW TO CHANGE THE FADER UNIT HOW TO REMOVE THE TOP PANEL○1Remove all slide fader knobs' and screws onthe top panel.○2Remove the top panel. HOW T