Vestax CDX-16 Manual de usuario Pagina 1

OWNER'S MANUALVESTAX CORPORATIONVESTAX EUROPE

10REMAINCONTINUEAUTO CUE SINGLE aPLAYgTRACK No. hMINUTES iSECONDS jFRAMES kREMAINcCONTINUE eTIME BARbPAUSE dAUTO CUE SINGLE fPITCH DISPLAY⑯DISPLAY [

11MIXER SECTION⑰ INPUT SELECT SWITCHUsed to select the input source (Phono, Line, CD) sent to thedesignated PGM (A,B).⑱ MONITOR SELECT SWITCHUsed to s

12POWER SPEAKER SPEAKERTURN TABLE 〔ex：VESTAX PDX-2000〕 CD PLAYER 〔ex：VESTAX CDX-35〕 LINE INPHONO INOUTPUTOUTPUTGNDGNDLINE INMIX OUTPOWER AMP［ex : V

13GETTING THE MOST OUT OF THE CDX-161.Switch your CDX-16 on, you'll find the on/off switch on the left side of therear panel.2.Open the CD tray(s

14SPECIFICATIONSTotal Power requirement 115V/230V AC, 35WWeight 6.8kgDimensions (W×H×D) 441×321×126(mm)CD SECTIONQuantization 16bit linerSampling Freq

Vestax CorporationDEC.2002.CDX16E①

2CONGRATULATIONS !Thank you for purchasing the Vestax CDX-16 CD Mixing Console. Wesuggest that you read through this owner's manual thoroughly s

3NOTEThis equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limit

41. Read instructions-All the safety and operatinginstructions should be read before the appliance isoperated.2. Retain instructions-The safety and op

517. Servicing-Do not attempt to service productyourself as opening or removing covers may exposeyou to dangerrous voltage or other hazards. Referall

6BEFORE USEUsing CDs.A conventional CD consists of two (2) sides. Typically one side bears a label stating the name of the CD and artistwhilst the fro

7（→FRONT PANEL）（→FRONT PANEL）↓（FRONT SIDE）↓（FRONT SIDE） CD SECTION①PITCH CONTROL FADERUsed to adjust the playing pitch (speed) by up to +/- 8%, +/-16

8[3] Search FunctionWhilst pause is activated, the joystick when moved from left to right will do so in 1-75 frame units for thepurpose of aiding trac

9AUTO CUE SINGLE⑩CUE INDICATOR When the cue point is set the LED will be on.⑪SINGLE / CONTINUE BUTTON This button is used to switch between single pla